Govt. Women’s Polytechnic College, Kaimanam,
Thiruvananthapuram
Department of Electronics
Model questions for Computer
Hardware and Networking Lab
1.
Partition
a given HDD into 4 numbers of drives with capacity 40%, 30%, 15% and 15% of
total space, and install windows in first partition
2.
Prepare
a given HDD with 3 equal partitions, and install Windows in first partition
3.
Trouble
shoot a given dead PC and make it operational and load any O/S
4.
Prepare
configuration list of a given PC by disassembly , and then assemble
5.
Install
a given Printer and print a document prepared with Microsoft office after
installing Office
6.
Prepare
UTP cable and test the cable in a LAN.
7.
Check
a Given SMPS and verify the voltage levels
8.
Given
a PC preloaded with Windows O/S. Load Linux on the same PC as second O/S to
make it dual boot.
9.
Install
Windows O/S on a given PC and install MS-office
10. Install Linux on a given PC and
connect with LAN to access internet
11. Install MS office in a given PC
and print a document after installing a given printer.
12. Given a PC preloaded with Windows
O/S, install antivirus and scan for virus.
13. Setup a computer with dual boot
operating systems
14. Given a computer with Windows OS,
connect the system to LAN using a wireless adapter, use ip as 192.168.1.150.
15. Given two numbers of PC preloaded
with windows O/S and a network switch. Setup the network for remote login from
both systems
16. Given a computer with Windows OS,
connect the system to LAN using a given PCIe type NIC card, use ip as
192.168.1.151.
17. Given a computer LAN, install a
printer in any one system and make the printer shared on the network.
18. Given a computer LAN, set IP
address in the systems starting from 192.168.1.100 and enable file sharing
between any two systems
19. Given a PC with preloaded
windows. Install motherboard drivers.
20. Given a LAN, and internet
connection. Configure a server to share internet through LAN.
No comments:
Post a Comment